Setek wireless range extender users prefer updating its firmware in order to enhance the performance of their devices. However, certain times, they come across the Setek extender firmware update failure issue while trying to do so.
Have you got a Setek WiFi extender set up done too? Are you also having a hard time because of the firmware update failed issue? Is that’s a yes we see? Well then, it is highly suggested that you go through the hacks highlighted in this post. One of them will definitely prove to be a helping hand for you.
[Fixed] Setek Extender Firmware Update Failure Issue
-
Update the Firmware Again
Sometimes, the only reason that causes issues with networking devices is technical glitches. These glitches can be taken care of if you simply try to update the firmware of your Setek wireless range extender from scratch. Thus, refer to the instructions given in the user manual of your networking device and update its firmware to its latest version.
-
Check the Cable Connection
Another reason why you are experiencing the issue at hand is because of a lousy internet connection. An unstable internet connection might have been caused because the cable connecting the networking devices is damaged. Thus, replace the damaged cable with a non-damaged one. When you connect your extender to the router using the new cable, make sure that the connection is finger-tight. Doing so will keep you away from further technical issues in the future.
-
Bring the WiFi Devices Closer
In case you are still experiencing the Setek extender firmware update failure issue, then it might be because the distance that is separating your networking devices currently is too much. To take care of the problem, you have got to reduce the distance between them. But, avoid placing them too close to each other. Otherwise, the signals emitted from your networking devices will clash and you will not be able to troubleshoot the Setek extender firmware update failure issue with ease.
-
Download the Right Version
Every Setek wireless range extender has a model number attached at its bottom. Surely your networking device would have come with the same. This model number is required while upgrading the firmware of your networking device. In case you entered the wrong model number when and where required, then it is no shocker why you are stuck with the Setek firmware update failed issue. To take care of the problem, you need to enter the correct model number while downloading the firmware of your wireless range extender.
-
Reboot the Setek Extender
Considering you are walking through this troubleshooting hack, it means that you are still struggling with the same issue. Well then, have you considered rebooting your wireless range extender to handle the situation at hand? No? Well then, you ought to do so now. You will be able to do so by powering off your extender, holding on for some time, and then, powering on your extender. Now, check again if you are able to update the firmware of your Setek range extender this time or if you are still stuck.
-
Do Setek Extender Reset
This is a troubleshooting hack that we usually recommend to users when nothing seems to work for them. It looks like we have to suggest you do reset as well. Now, you might be wondering how to restore your wireless range extender to its default factory values, right? Well, it is quite simple. You just need to press the Reset button located on it and hold on for some time. Once the reset process finishes, your wireless extender will automatically reboot signifying the same. Now set it up once again. If you have connected Setek WiFi Extender to T-Mobile network, then run through the configuration steps to connect WiFi extender to extend router’s range.
To Conclude
As mentioned in this article, performing Setek extender firmware update is important if you want to enhance the performance of your networking device. But, if that is exactly what you are not able to do, then we hope that the aforementioned troubleshooting hacks will be able to help you out.