The constant appearance of the routerlogin.net not working error message can become really frustrating, especially when you want to change the password of your Netgear router. Well, the good news is that I can help you in troubleshooting this issue. But, a little coordination is needed from your side too. Don’t worry, you don’t have to do much. All you need to do is, carefully go through the steps mentioned in this post. I’ll guide you through the rest. Read on.
Why Are You Seeing the Routerlogin.net Not Working Error Message?
There can be a number of reasons stopping you from accessing routerlogin page. Some of the most common reasons are:
- Outdated or corrupted firmware
- Incorrect web address
- Poor internet connection
- Unstable connection between the router and modem
- Worn our Ethernet cable
Now that you are well aware of the factors causing the routerlogin.net not working issue, take the help of the below-mentioned troubleshooting steps to fix it.
Fixed: Routerlogin.net Not Working
Use the Correct Web Address
One of the major reasons why you’re facing the routerlogin.net not working is because you weren’t careful enough while entering the default web address. To fix the issue, it is recommended that you keep your eyes open while using the default web address of your router.
The default web address of your Netgear router is routerlogin.net. In case, even entering the correct web address doesn’t work in your favor, then it is recommended that you use the default IP to log into your device.
Have a Strong Internet Connection
Another common reason why you aren’t able to perform Netgear router login is a poor internet connection. A poor internet connection can exist because of two reasons – improper connection between the router and modem or your ISP is at fault.
Thus, first confirm whether the internet issue is from the end of your ISP. In case it is, ask him to get the issue fixed. In case it isn’t, then it means that the connection between your router and modem is unstable. Chances are that you’ve connected your devices wirelessly which has caused the fuss. To fix the issue, make sure that your devices are connected with an Ethernet cable.
However, you can also perform the Netgear extender setup to enhance the internet connectivity throughout the house. Once the extender is installed you will get the blazing fast internet speed.
Quick Tip: Just make sure that the Ethernet cable that you’re using is free of damages.
Perform Factory Default Reset
If the aforementioned tips didn’t help you resolve the routerlogin not working issue, then it is recommended that you reset your device. Resetting your device means restoring it to its factory default settings. In simple words, whatever changes you’ve made to your Netgear WiFi router till date will get erased.
Here are the step-by-step guidelines you should follow to reset your Netgear WiFi router:
- Connect your router to the power adapter using a power cable.
- Plug the Power adapter into the wall socket and turn on your WiFi device.
- Create a connection between your router and existing modem.
- Locate the Reset button on your router. It is usually located at the bottom.
- Once you find the Reset button, press it carefully.
- Use an oil pin, tooth pick, paper clip, or any other sharp object to press the Reset button.
- Hold the button for approximately 30 seconds before releasing it.
And you are done! In this manner, you’ll be able to restore your Netgear WiFi router to its factory default settings.
Summing Up
Hopefully, the aforementioned steps would’ve helped you in troubleshooting the Netgear routerlogin.net not working issue. On the off chance, if the issue persists, then it is recommended that you power cycle your Netgear WiFi device. Chances are that doing so might work for you.